Ping [-t] [-a] [-n count] [-l size] [-f] [-i TTL] [-v TOS]
[-r count] [-s count] [[-j host-list] | [-k host-list]]
[-w timeout] destination-list
Options:
-t Pings the specified host until stopped.
To see statistics and continue - type Control-Break;
To stop - press Ctrl + C.
-a Resolve addresses to hostnames.
-n count Number of echo requests to send.
-l size Send buffer size.
-f Set Don't Fragment flag in packet.
-i TTL Time To Live.
-v TOS Type Of Service.
-r count Record route for count hops.
-s count Timestamp for count hops.
-j host-list Loose source route along host-list.
-k host-list Strict source route along host-list.
-w timeout Timeout in milliseconds to wait for each re
Examples
ping localhost
Pings the local host, this will allow you to see if the computer is able to send information out and receive the information back. Note that this does not send information over a network but may allow you to see if the card is being seen.
ping xxx.xxx.xxx.xxx
Allows you to ping another computer where the x's are located are where you would place the IP address of the computer you are attempting to ping. If this is not able to complete, this should relay back an unsuccessful message, which could be an indication of cable issues, network card issues, hub issue, etc.
Additional information
Is there a continuous ping options?
ping -t
Use the -t option to ping any address until you cancel it by pressing Ctrl + C.
